Page 3 of 3

Re: My Street Hawk Series Bike Project

Posted: Fri Dec 21, 2012 5:02 am
by JON1482
Looks spot on Tom. The bike build is a massive challenge but when you can find bits and bobs that look the part it makes it a little sweeter :)

Re: My Street Hawk Series Bike Project

Posted: Fri Dec 21, 2012 11:12 pm
by spyhunter2k
I agree. Looks just the right size.

Re: My Street Hawk Series Bike Project

Posted: Sun Feb 03, 2013 11:23 am
by Guido
Hey Jameth,

you maybe should check out the for sale section as I have a very nice parts set up for sale and I think you possible could use it on your built up.

Greetings Guido

Re: My Street Hawk Series Bike Project

Posted: Thu Aug 30, 2018 8:43 pm
by jesse1
That control weapon's POD is not correct. I know, I have one of the originals. I put the original on my new XR650L Honda

Re: My Street Hawk Series Bike Project

Posted: Thu Aug 30, 2018 10:55 pm
by jesse1
There was no dash detail (only black Plexiglas) or buttons on all Streethawk Bikes, except for the 2 prototypes used on the 1st show.

I have pictures and information on these bikes that will make you guys pee your pants. especially the prototypes.

Re: My Street Hawk Series Bike Project

Posted: Fri Aug 31, 2018 4:32 pm
by JON1482
This is Street Hawk GOLD!

Re: My Street Hawk Series Bike Project

Posted: Fri Aug 31, 2018 5:44 pm
by jesse1
There were 3 POD controllers. "Not in any order"

One was the cylinder type which I showed you today in my pictures. They were used on the XR500'S.

The second one, was a silver universal electronics project box (radio shack carried them until they went out of business.) used on the CR250's with red buttons on to ignite the fire extinguishers during jump scenes.

The 3rd type: The shell type used on the prototypes

Also, the machine gun used was compressed air sticking out of the barrel, There was a solenoid that opened and closed rapidly causing a popping noise. POP POP POP!